SniffLab: Setup Your Own MITM, Packet Sniffing WiFi Access Point

Setting up a SNIFFLAB
Scripts to create your own MITM'ing, packet sniffing WiFi access point.

Firewall rules on DD-WRT router to send traffic to MITM proxy box

Make sure the network interface (vlan1 here) is correct.

PROXYIP=your.proxy.ip
iptables -t mangle -A PREROUTING -j ACCEPT -p tcp -m multiport --dports 80,443 -s $PROXYIP
iptables -t mangle -A PREROUTING -j MARK --set-mark 3 -p tcp -m multiport --dports 80,443
ip rule add fwmark 3 table 2
ip route add default via $PROXYIP dev vlan1 table 2

PCAP machine scripts

/etc/network/interfaces

auto lo
iface lo inet loopback
iface eth0 inet manual
iface eth1 inet manual
allow-hotplug wlan0
iface wlan0 inet dhcp
wpa-conf /etc/wpa_supplicant/wpa_supplicant.conf
iface default inet dhcp

auto bond0
iface bond0 inet dhcp
bond-mode 3
bond-miimon 100
slaves eth0 eth1
/etc/wpa_supplicant/wpa_supplicant.conf

ctrl_interface=DIR=/var/run/wpa_supplicant GROUP=netdev
update_config=1

network={
        ssid=""
        psk=hashofyourpassword
        proto=RSN
        key_mgmt=WPA-PSK
        pairwise=TKIP
        auth_alg=OPEN
}

Getting the network running correctly on boot

/etc/init.d/network.sh

#!/bin/sh
### BEGIN INIT INFO
# Provides:     network.sh
# Short-Description:    Ensure WiFi as well as Ethernet interfaces are up
# Description:
# Default-Start:    2 3 4 5
# Default-Stop:     0 1 6
# Required-Start:   $remote_fs $syslog
# Required-Stop:    $remote_fs $syslog
### END INIT INFO
sudo ifplugd eth0 --kill
sudo ifup wlan0
sudo ifup eth0
sudo ifup eth1
sudo ifconfig eth1 promisc
sudo ifconfig eth0 promisc
exit 0

Start capturing packets on startup -- create a sniffer service

/etc/init/sniffer.conf

#sniffer.conf
start on runlevel [2345]
stop on runlevel [016]

script
    cd /home/pi/snifflab
    exec python sniffer.py -i bond0 -s 100 -t 1200
end script

MITM proxy service

mitm.conf

start on filesystem

script
    sudo iptables -A PREROUTING -t nat -i em1 -p tcp -m multiport --dports 80,443 -j REDIRECT --to-port 4567
    SSLKEYLOGFILE=/var/log/mitmkeys.log
    export SSLKEYLOGFILE
    echo "MITM Keys being logged here: $SSLKEYLOGFILE"
    exec mitmdump -T --host --conf=/etc/mitmproxy/common.conf
end script

Script to backup pcaps to local machine

#!/bin/bash
remote_server=yourservername
pcap_dir=/pcaps
keylogfile=/var/log/mitmkeys.log
local_dir=~/Documents/snifflab

rsync -a "$remote_server":$pcap_dir $local_dir
scp "$remote_server":$keylogfile $local_dir

Download